The architecture of Tartaria and its phenomena show the potential for an electricity tapping mechanism, in which the existing architecture when built was already part of the system for tapping energy from the Ether. Most people have only a vague idea of Ether, the statements about Ether are mostly correct at the vague level, the wrong statements and wrong definitions of Ether are all conspiracies. For example, the Ether search experiment, the Michelson–Morley experiment, had a wrong definition of Ether from the beginning when it assumed that "Luminiferous aether" was the main force of Ether. Furthermore, this experiment was based on the heliocentric model, the rotating spherical earth to consider Ether in the universe. In fact, the heliocentric model is still just a theory, and in recent years, many experts have proven that the flat earth is true to reality.
I would like to introduce a stationary generator that generates electricity, at least to light a light bulb from a circuit with a starting device of a battery.
That is the Free Energy Resonant Transformer circuit. Generally, it can be designed to be hidden in the house, and just turning on the switch will allow the generation of electricity. This is a Tartarian-style device, and may have been used in the past.
# Circuit diagram and brief explanation
The primary and secondary coils of this transformer are connected to each other through an electronic switch, which is a reverse transistor, denoted by Q1 and Q2 in the diagram. This connection is to create resonance, promoting each other. That is why this is also called a free energy resonance transformer.
The diagram is as follows:
Note the transformer symbol in the image above. The special thing is that the primary and secondary coils are usually wound on a ferrite toroidal core. This allows just a small device installed in each floor of the house to be enough to supply electricity to each floor of the entire high-rise building (a structure that may have occurred in the Tartarian era).
Brief explanation:
The input signal consists of 2 components: the battery with switch Z (as shown in the picture) and the signal from the antenna. With the signal from the antenna, it can be replaced by a signal of square pulses, and this signal can be ignored and the transformer will still operate. The signal is added to increase the capacity and frequency of the transformer, it can be ignored, not needed at the beginning for the circuit to operate.
The most important thing in this system is to use a long copper bar to connect to the ground deeply. After the copper bar is deeply inserted into the ground, kept moist, the end protruding from the ground must have a voltage of 0.7 V or more. This means using a voltmeter, measure the voltage at the copper terminal relative to the negative terminal of a 12V battery. The voltage must be greater than 0.6V - 0.7V.
If this is not achieved, the system does not work. Because that is the voltage for transistor Q1 to open at pins B and E (see figure). The voltage must be greater than 0.6V for Q1 to allow current to pass through BE.
When this is achieved, closing the switch Z to apply voltage from the battery to the system will be like a starting action for the transformer to operate.
When the light is on, you can open the switch Z, because at this time the system is oscillating, resonating, promoting each other. The maximum voltage threshold depends on the impedance and frequency of the voltage on the coil (the frequency is obtained by the switches Q1 and Q2 closing - opening). The polarized capacitor has now replaced the battery.
To further exploit and promote other frequencies in space, a radiant energy receiving antenna can be installed in the sky (similar to Nikola Tesla's invention of the radiant energy receiver in 1901).
At that time, although the power from the starting battery is cut off, there is still energy at the output. The energy is promoted by the antenna or oscillator with very small power.
The component indexes and the number of turns of the transformer are shown in the picture.
# Installation components and notes
Here is the list of electronic components for the Motionless Electricity Generator - Free Energy Resonant Transformer circuit:
+ Transistor 2N3055 or MPSA06: 15A 100V 115W 2N3055 NPN Transistors OR: MPSA06 Transistor AMP NPN
+ Electrolytic capacitor (polarized) 5V to 50V 10000 uF: capacitor 5V to 50V 10000uF OR: 50V 10000uF 25x50 25x50mm 2 Pin Solder Snap-in Terminal Electrolytic Capacitor (Remember that you must choose a polarized capacitor or an electrochemical capacitor).
+ Long cylindrical copper pole, large enough diameter
+ Diode: 30A 50V Blocking Bypass Barrier Diodes
+ Permanent magnet oriented Ether field
+ Control oscillator to increase power and maintain resonance state when overloaded: Pulse Signal Generator
Some cheaper, more unique, similar electrical devices can be found here: https://easy-power-plan-dcp.blogspot.com/p/electrical-devices.html
Note:
A voltmeter is needed to measure the voltage between the copper pole and the negative pole of the battery. When the voltage is not greater than 0.6V, it is necessary to insert the copper pole deeper. You can find a long and large copper bar at the scrap yard, which is better than buying it on the market. Because the copper bars sold today are short and small.
The voltage at the negative pole of the battery is calculated as 0V, equal to the voltage at point E as shown in the picture, and the voltage between NE is about 0.7V, which means the copper bar must protrude from the ground about NE (see picture).
The voltage at the negative pole of the battery is calculated as 0V, equal to the voltage at point E as shown in the picture, and the voltage between NE is about 0.7V, which means the copper bar must protrude from the ground about NE (see picture).
Note point K in the picture, which is where the output signal is extracted. Therefore, you can install 4 Diodes into a bridge rectifier yourself, to charge a battery bank. This is to store energy when the electricity is not in use. Behind the battery bank is an inverter that will convert DC to AC. About 20 batteries in parallel, with 2 outputs fed into the inverter, is enough to comfortably power a family of 5. The system will recharge at night while you sleep.
I recommend you to use old batteries, Lead Acid batteries and use rain to add water (no need to use Acid to add when charging). Because it is quite cheap and does not cause fire or explosion. You can use a broken battery from a junkyard to maintain the bipolarity if there is "Cold Electricity" to charge it. With this system, I am not sure if there is "Cold Electricity" or not, but you should try it.
# Final words:
This is a free energy, resonant transformer, which has a model quite similar to the understanding of Tartarian technology (an empire hidden from official history). It is also called Motionless Electricity Generator.
Historians believe that the Tartarian era harnessed energy from Aether (Ether), with a static state. But with this circuit, if the Antenna is used to maintain and increase the power, it can be said that the generator is exploiting energy from the Ether. But in fact, the Antenna can be ignored, the circuit still works! So where does the Energy come from?
“All matter is crystalline, all matter is frozen light.” -- Walter Russell
Raw matter, such as a coil, is actually a state of Ether. Understanding the nature of light will understand the nature of raw matter (solid). The atom with the model of electrons rotating around like a cloud is still just a theory that leads to many contradictions. The non-existence of electrons has been proven by mathematics and physics. But this is a long issue that cannot be presented here. The truth will ensure freedom and progress for many people. The information I mentioned may be contrary to many scholars, but I mentioned it to let historical investigators take the lead in investigating and searching for the truth. That is the main intention when I mentioned this.
Free energy is not the prerequisite for humans to regain their position in history. But anyway, free energy will help humans create more material wealth, create a richer world without needing a lot of bank money as a means of exchange.
A rich family or a rich country does not necessarily need a lot of cash or a lot of cryptocurrency. If there is a consensus on technology sharing between the government and the people, the world can be rich without having to worry about money all day long. This may have existed in the Tartaria era - A world of harmony and peace.
Therefore, I introduce a series of books containing many plans and different methods to exploit Ether energy, free energy:
⭐ An additional book series containing easy methods to create free energy generators, and this series also contains other technologies, including Tesla technology.
👉 Here is the book: Easy Power Plan Will Change Our World Forever 🔗
📖 That book may contain more advanced free energy technology in the modern version.
An article on Tesla and Tartaria technology - for those who are interested in Tartaria: Two examples of Nikola Tesla reverse-engineered Tartarian technology - consider "Tesla & The Cabbage Patch Babies” by Guy Anderson
I wish you success in making the Motionless Electricity Generator and good luck!